ELECTRICITY - Class 10 Physics Notes (PDF · 8 pages · Free download) Download the full PDF free
Preview: first 2 pages


You are looking at pages 1 to 2 of 8. The full PDF is free to download.
Why does the element of an electric heater glow red-hot while the cord that carries the same current stays cool? The cord is thick copper with almost no resistance; the element is nichrome with a very high one. That reasoning question, with its answer, is on page 6 of these master study notes for CBSE Class 10 Science (Physics), Chapter 11: Electricity. The PDF has 8 pages of topic-wise notes ending in a formula sheet and a list of ten must-remember facts. It is free to download, prepared by Qtutor, and is not an official CBSE or NCERT publication.
What is included
- A chapter overview, then eight topics of class 10 electricity notes in the order of the NCERT chapter
- Definitions of the ampere, volt, ohm and watt, each with its formula
- A table of circuit symbols described in words (cell, battery, plug key, ammeter, voltmeter, rheostat, bulb)
- A table classifying conductors, alloys and insulators with their uses
- Derivations of equivalent resistance for series and parallel combinations, and a series vs parallel comparison table
- Joule's law of heating with its derivation, and three applications: heating devices, the electric bulb and the fuse
- Electric power, the kilowatt-hour and a worked electricity bill calculation
- Section D: a master formula sheet with SI units and measuring instruments, and the "Top 10" facts
Structure
| Topic | What it covers | Page |
|---|---|---|
| 1 | Electric current and electric circuit | 1 |
| 2 | Electric potential and potential difference, circuit symbols | 2 |
| 3 | Ohm's law, resistance, V-I graph | 3 |
| 4 | Factors affecting resistance, resistivity, types of material | 4 |
| 5 | Resistors in series and in parallel | 5 |
| 6 and 7 | Heating effect of current and its applications | 6 |
| 8 | Electric power and the commercial unit of energy | 7 |
| Section D | Formula sheet and Top 10 facts | 8 |
Key topics covered
- Electric current, I = Q/t, and the number of electrons in one coulomb
- Conventional current and electron flow
- Why an ammeter is connected in series and a voltmeter in parallel
- Ohm's law and the slope of the V-I graph
- Resistance and resistivity, R = ρl/A
- Why nichrome is used in heating elements and tungsten in bulb filaments
- Equivalent resistance in series and in parallel; why homes are wired in parallel
- Joule's law, H = I²Rt
- Power, P = VI = I²R = V²/R, and 1 kWh in joules
Sample from this PDF
Note points taken from the PDF
- One ampere is the current when one coulomb of charge flows through a conductor in one second.
- Number of electrons in 1 C of charge: n = Q/e = 1/(1.6 × 10⁻¹⁹) = 6.25 × 10¹⁸.
- An ammeter has very low resistance and is connected in series; a voltmeter has very high resistance and is connected in parallel.
- On a graph with V on the y-axis and I on the x-axis, the slope gives the resistance. If the resistance is doubled at constant voltage, the current becomes half.
- Resistivity depends only on the nature of the material and the temperature. Cutting or stretching a wire changes its resistance but not its resistivity.
- If a wire of resistance R is stretched to double its length without changing its volume, its area of cross-section becomes half and its resistance becomes 4R.
- In series the same current flows through every resistor and the equivalent resistance is greater than the largest resistance. In parallel the potential difference is the same across every resistor and the equivalent resistance is smaller than the smallest one.
- A fuse is connected in series with the live wire. Its wire has a low melting point, so excess current melts it and breaks the circuit.
- 1 kWh = 1000 W × 3600 s = 3.6 × 10⁶ J.
- At the same voltage, P = V²/R, so a bulb of higher wattage has lower resistance.
Worked example from page 7
An electric heater rated 1000 W is used for 2 hours a day for 30 days. Find the cost at Rs 5 per unit. Energy = (1000 × 2 × 30)/1000 = 60 kWh, that is 60 units. Cost = 60 × 5 = Rs 300.
How it helps
- Every definition is followed at once by its formula and unit, which is how a 2-mark "define and state the SI unit" answer is written
- Both equivalent resistance derivations are set out line by line, ready to reproduce in a 3-mark answer
- The "why" points (nichrome, tungsten, parallel wiring, the cool cord) cover the reasoning questions asked most often from this chapter
- The formula sheet on the last page lists ten quantities with symbol, formula, unit and instrument in one table
Who should use it
- Class 10 students who want class 10 science electricity short notes for revision before a test or the board exam
- Students who can state Ohm's law but mix up the four power formulas
- Tutors who need a single handout that covers the chapter's theory
Download the PDF
ELECTRICITY - Class 10 Physics Notes (PDF · 8 pages · Free download)
The chapter page lists all resources for this chapter: Class 10 Physics Electricity.
Related resources
- Electricity application questions and answers (free, 100 questions)
- Light Reflection and Refraction master study notes
- Human Eye and the Colourful World chapter short notes
- All Class 10 Physics chapters
Frequently asked questions
Small black bars appear in formulas such as "V = V + V + V" on page 5. What is missing?
The subscripts. In this PDF the small numbers 1, 2, 3 and the letter s or p did not print, and some powers of ten in the resistivity table are affected in the same way. Read the series result as Rs = R1 + R2 + R3 and the parallel result as 1/Rp = 1/R1 + 1/R2 + 1/R3.
Do the Electricity notes include numericals?
Only short ones inside the notes: the number of electrons in a coulomb, the conversion of 1 kWh to joules and one electricity bill problem. For numerical practice use the application question bank linked above.
Are circuit diagrams drawn in the PDF?
No. The circuit symbols are described in words in a table. Learn to draw them from the NCERT textbook, since the board asks for circuit diagrams.
Is Electricity Chapter 11 or Chapter 12?
The PDF calls it Chapter 11. The number can differ with the edition of the NCERT textbook; the content is the chapter named Electricity.
Which page should I read the night before the exam?
Page 8. It has the formula sheet and the ten facts, including the 4R result for a stretched wire and 1 kWh = 3.6 × 10⁶ J.
Write the four formulas for power and the two for equivalent resistance on a blank sheet, then solve one bill calculation with your own appliance and hours. Go to the Electricity chapter page for more.
