Chapter 4: Electricity: Magnetic and Heating Effects

Class 8 Science notes: summary, key points, important questions and MCQs.

  • Class 8
  • Science
  • Chapter 4
  • CBSE 2026–27
  • Last updated: 19 Nov 2026

Chapter summary

Class 8 Science Chapter 4 Electricity: Magnetic and Heating Effects (NCERT Curiosity, CBSE 2026-27) explains what an electric current can do besides lighting a lamp. A compass placed under a current-carrying wire deflects, which shows the magnetic effect of electric current, first noticed by Hans Christian Oersted in 1820. A coil carrying current behaves as a magnet called an electromagnet; an iron core makes it much stronger, more current or more turns make it stronger still, and reversing the current swaps its poles. Lifting electromagnets on cranes switch on to lift iron and off to release it.

The chapter also covers the heating effect of current: resistance turns part of the electrical energy into heat, which is why nichrome is used in heaters, kettles and irons. Finally, it shows how cells make electricity by chemical reactions: the Voltaic cell, a lemon cell, the dry cell and rechargeable batteries, and why used batteries go to e-waste recycling.

Key points and definitions

  • A wire carrying electric current produces a magnetic field around it; this is the magnetic effect of electric current.
  • A compass needle under a current-carrying wire deflects and returns to its original direction when the current stops.
  • Hans Christian Oersted discovered the link between electricity and magnetism in 1820.
  • A current-carrying coil that behaves as a magnet is an electromagnet; most have an iron core to make them stronger.
  • An electromagnet has north and south poles; reversing the direction of current reverses its poles.
  • The strength of an electromagnet increases with more current (more cells) and more turns of the coil.
  • Lifting electromagnets on cranes lift iron and steel when switched ON and release it when switched OFF.
  • Every conductor offers resistance to current, which converts some electrical energy into heat: the heating effect of electric current.
  • Heat produced in a wire depends on the current, its material, thickness and length, and how long the current flows.
  • Nichrome has higher resistance than copper of the same size, so it is used in heating elements of heaters, kettles and irons.
  • A Voltaic cell has two different metal electrodes in an electrolyte; a lemon cell uses copper and an iron nail in lemon juice.
  • A dry cell has a zinc container (negative), a carbon rod with metal cap (positive) and a paste electrolyte; it is single-use, while rechargeable batteries such as Li-ion can be reused many times.

Important questions

  1. How can you find out if current is flowing in a circuit that has no lamp?

    Place a magnetic compass under a wire of the circuit. If the needle deflects when the switch is closed, current is flowing, because a current-carrying wire produces a magnetic field.

  2. What is an electromagnet? Why do most electromagnets have an iron core?

    An electromagnet is a coil that behaves as a magnet when current flows through it. An iron core inside the coil makes the electromagnet much stronger.

  3. The north pole of a compass is attracted to end A of an electromagnet. What is the polarity of end A? What happens if the current is reversed?

    End A is a south pole, because unlike poles attract. If the current is reversed, the poles swap and end A becomes a north pole.

  4. Give two ways to increase the strength of an electromagnet.

    Increase the current (use a battery of more cells) and increase the number of turns of the coil.

  5. Why are electromagnets, not permanent magnets, used on cranes in scrap yards?

    The magnetism of an electromagnet disappears when the current is switched off, so the crane operator can lift a load and release it exactly where it is needed.

  6. Why does a nichrome wire get warm when current flows through it?

    Every conductor offers resistance to current. This resistance converts part of the electrical energy into heat. Nichrome has higher resistance than copper of the same size, so it heats up noticeably.

  7. Sumana leaves her electromagnet switched on. After some time it stops lifting clips, but the wire is still warm. Give possible reasons.

    The cell gets used up (weakens) when connected for a long time, so the current becomes too small to make a strong magnetic field. The warmth is due to the heating effect of the current that flowed.

  8. Will an LED glow in a cell made with an iron nail and a copper strip in pure water instead of lemon juice?

    No, or only very poorly. Lemon juice is the electrolyte that helps conduct electricity and react with the electrodes; pure water does not do this job.

  9. Name the parts of a dry cell and state which are the positive and negative terminals.

    A dry cell has a zinc container (negative terminal), a carbon rod in the centre covered with a metal cap (positive terminal) and a paste-like electrolyte around the carbon rod.

  10. Why should used batteries be sent to e-waste recycling points?

    They may still contain acids and metals like lead, cadmium, nickel or lithium that can cause fires or harm the environment, and many of their materials are valuable and can be recycled.

MCQs with answers

  1. When current flows through a nichrome wire for a short time, which is correct? (i) The wire becomes warm. (ii) A compass below the wire deflects.

    1. Only (i)
    2. Only (ii)
    3. Both (i) and (ii)
    4. Neither (i) nor (ii)
    Show answer

    Answer: (c) Both (i) and (ii)

  2. Which change will NOT make an electromagnet stronger?

    1. More turns in the coil
    2. Using 2 cells instead of 1
    3. Inserting an iron core
    4. Reversing the direction of current
    Show answer

    Answer: (d) Reversing the direction of current

  3. The solution used in a Voltaic cell is called the:

    1. Electrode
    2. Electrolyte
    3. Conductor
    4. Insulator
    Show answer

    Answer: (b) Electrolyte

  4. Nichrome wire is used in heating devices because it:

    1. is an insulator
    2. is cheaper than copper
    3. generates more heat for a given current
    4. is magnetic
    Show answer

    Answer: (c) generates more heat for a given current

  5. In a dry cell, the negative terminal is the:

    1. Carbon rod
    2. Metal cap
    3. Zinc container
    4. Paste electrolyte
    Show answer

    Answer: (c) Zinc container

Download full PDF notes

Question Bank

Chapter Note

NCERT Solutions

Frequently asked questions

  • What is the magnetic effect of electric current in Class 8 Science Chapter 4?

    When electric current flows through a conductor like a wire, it produces a magnetic field around it. A compass needle placed near the wire deflects. The field disappears when the current stops.

  • What is an electromagnet Class 8?

    An electromagnet is a current-carrying coil that behaves like a magnet. It usually has an iron core, its strength rises with current and number of turns, and its poles reverse when the current is reversed.

  • What is the heating effect of electric current Class 8?

    A conductor gets heated when current passes through it because its resistance converts part of the electrical energy into heat. Heaters, kettles, irons and immersion rods work on this principle.

  • How does a lemon battery work Class 8?

    A copper wire and an iron nail are pushed into a lemon. The lemon juice acts as the electrolyte and a chemical reaction produces current. Several lemons joined in a chain (nail to copper) can light an LED.

  • Why is a dry cell called dry?

    Because its electrolyte is a thick, moist paste instead of a liquid.

  • Where can I download Class 8 Science Chapter 4 Electricity: Magnetic and Heating Effects notes PDF?

    Chapter notes for Class 8 Science Chapter 4 are listed in the downloads section of this page, along with other study materials for the chapter.

  • More Class 8 Science chapters