Class 9 · Chemistry

Chapter 5: Exploring Mixtures and their Separation

Class 9 Chemistry notes: summary, key points, important questions and MCQs.

Chapter summary

Exploring Mixtures and their Separation shows how everyday materials are mixtures and how their parts can be separated. Mixtures are homogeneous, with a uniform composition such as salt solution or brass, or heterogeneous, such as sand in water or smoke. They are also grouped as solutions, suspensions and colloids. The chapter defines solute, solvent and concentration, and works out mass by mass, mass by volume and volume by volume percentages with real examples such as ORS, 0.9% saline drips, vinegar, talcum powder and cake mixes. Solubility depends on temperature, and solubility curves show why some salts crystallise on cooling. Separation methods are matched to the property they use: crystallization, simple and fractional distillation, paper chromatography, separating funnels for immiscible liquids, sublimation for camphor or naphthalene, centrifugation for blood, and coagulation with alum for muddy water. The chapter ends with colloids, particle sizes and the Tyndall effect. The PDF is a 31-page set of 119 flash cards with definitions, solved numericals, labelled apparatus diagrams, MCQs and assertion-reason questions.

Key points and definitions

  • Homogeneous mixtures have a uniform composition (salt solution, vinegar, brass); heterogeneous mixtures do not (sand and water, oil and water, smoke).
  • A solution has a solute dissolved in a solvent; concentration is the amount of solute in a given amount of solution.
  • % m/m = mass of solute ÷ mass of solution × 100; % m/v uses volume of solution in mL; % v/v is used for two liquids.
  • Solubility is the maximum amount of solute that dissolves in a fixed amount of solvent at a given temperature.
  • Solids usually become more soluble as temperature rises, while gases become less soluble.
  • Crystallization separates a pure solid from a saturated solution by cooling; slow cooling gives larger crystals.
  • Distillation separates miscible liquids whose boiling points differ by about 25 °C or more; fractional distillation is used for smaller differences.
  • Paper chromatography separates coloured components by how fast they move with the solvent; the spot must stay above the solvent level.
  • A separating funnel separates immiscible liquids by density; sublimation separates substances like camphor from sand.
  • Centrifugation spins mixtures to separate heavier particles; alum (fitkari) coagulates fine particles in muddy water.
  • Particle size: solution below 1 nm, colloid 1–1000 nm, suspension above 1000 nm.
  • Colloids and suspensions scatter a light beam (Tyndall effect); true solutions do not.

Important questions

  1. How do homogeneous and heterogeneous mixtures differ? Give two examples of each.

    A homogeneous mixture has the same composition throughout, such as sugar solution and vinegar. A heterogeneous mixture is not uniform and its parts can often be seen, such as sand in water and oil in water.

  2. 10 g of salt is dissolved in 90 g of water. Find the mass by mass percentage.

    Mass of solution = 10 + 90 = 100 g. % m/m = 10 ÷ 100 × 100 = 10%.

  3. What does a hospital saline drip labelled 0.9% m/v mean?

    It contains 0.9 g of sodium chloride in every 100 mL of solution, a strength that is safe for blood and replaces lost fluids.

  4. Two tablespoons of 15 mL orange concentrate make 150 mL of juice. Find the % v/v.

    Volume of concentrate = 2 × 15 = 30 mL. % v/v = 30 ÷ 150 × 100 = 20%.

  5. Why is temperature always stated along with solubility?

    Solubility changes with temperature. Most solids dissolve more in hot water, while gases dissolve less as temperature rises.

  6. Why is a copper sulfate solution cooled slowly and without disturbance during crystallization?

    Slow, undisturbed cooling gives the particles time to arrange themselves, so larger, well-shaped crystals form. Rapid cooling gives small, poorly formed crystals.

  7. Why can acetone and water be separated by simple distillation?

    They are miscible, so filtering will not work, but their boiling points (about 56 °C and 100 °C) differ by more than 25 °C. Acetone boils off first and is condensed, leaving water behind.

  8. Why must the solvent level stay below the ink spot in paper chromatography?

    If the spot dips into the solvent, the colours dissolve into the liquid instead of rising up the paper, so no separation is seen.

  9. How would you separate a mixture of sand, salt and naphthalene?

    Heat gently so naphthalene sublimes and is removed. Add water to dissolve the salt, filter to leave sand as residue, then evaporate the filtrate to get salt.

  10. What would happen if blood behaved like a suspension?

    Blood cells would settle down instead of staying evenly spread, so blood could not carry nutrients, gases and hormones evenly to all parts of the body.

MCQs with answers

  1. Alcohol (b.p. 78 °C) and benzene (b.p. 80 °C) are best separated by:

    1. Simple distillation
    2. Fractional distillation
    3. Filtration
    4. Sublimation
    Show answer

    Answer: (b) Fractional distillation

  2. Which substance is used as a coagulant to clear muddy water?

    1. Common salt
    2. Alum
    3. Sugar
    4. Copper sulfate
    Show answer

    Answer: (b) Alum

  3. The particle size of a solute in a true solution is:

    1. Less than 1 nm
    2. 1–1000 nm
    3. More than 1000 nm
    4. Exactly 100 nm
    Show answer

    Answer: (a) Less than 1 nm

  4. Which mixture shows the Tyndall effect?

    1. Copper sulfate solution
    2. Salt solution
    3. Starch in water
    4. Acetone in water
    Show answer

    Answer: (c) Starch in water

  5. The process in which a vapour changes directly into a solid on cooling is:

    1. Sublimation
    2. Deposition
    3. Evaporation
    4. Crystallization
    Show answer

    Answer: (b) Deposition

Download full PDF notes

Question Bank

Chapter Note

Short Notes

WORKSHEET

flash cards

Frequently asked questions

  • What does this chapter cover?

    Types of mixtures, solutions and concentration, solubility and solubility curves, crystallization, distillation, chromatography, separating funnels, sublimation, centrifugation, coagulation, colloids and the Tyndall effect.

  • What type of material is the PDF?

    A 31-page set of 119 flash cards in 13 topic groups, with solved concentration numericals, labelled apparatus diagrams, MCQs and assertion-reason questions.

  • How do I choose the right separation method?

    Look at the property that differs: solubility (crystallization), boiling point (distillation), density (separating funnel), ability to sublime (sublimation), particle size and mass (filtration or centrifugation).

  • Are numericals included?

    Yes. The cards include % m/m, % m/v and % v/v problems and solubility-table questions with step-by-step answers.

  • More Class 9 Chemistry chapters